Changing file coordinates in millwizard

[myxpykalix]

I have a .stl of a file that was made that is 34 in Y and 5 in X and i'd like to change that so the 34 is in the X and 5 in the Y but can't figure out how to do that since it isn't one i made?

[scottcox]

Jack,

It looks like you're doing more and more work that "requires" a full 3D program. I would use Turbocad for that and have it done in less than a minute.

You can get into Turbocad a little cheaper by buying an old version (from ebay, etc.) then upgrading that.