porscheman
10-13-2008, 06:13 PM
I've noticed a strange behavior on my design/drafting computer that I'm curious if anyone else can replicate.
I'm using Partworks v1.1 and ShopBot Control Software v3.5.5 (in preview mode on this machine). Once I have finished creating a PW design and have saved the toolpaths, I start up the SB software in preview mode just to check things out one final time before I take the files down to my machine to cut. After I've previewed the SBP files, I close the SB software and for some strange reason, this also closes my Partworks application (which is minimized on the windows desktop). Obviously, I'd prefer that this not happen, especially if I haven't saved any final changes in the Partworks CRV files.
Has anyone else seen this? Any confirmation that this isn't just confined to my system would be appreciated.
Regards.
John
I'm using Partworks v1.1 and ShopBot Control Software v3.5.5 (in preview mode on this machine). Once I have finished creating a PW design and have saved the toolpaths, I start up the SB software in preview mode just to check things out one final time before I take the files down to my machine to cut. After I've previewed the SBP files, I close the SB software and for some strange reason, this also closes my Partworks application (which is minimized on the windows desktop). Obviously, I'd prefer that this not happen, especially if I haven't saved any final changes in the Partworks CRV files.
Has anyone else seen this? Any confirmation that this isn't just confined to my system would be appreciated.
Regards.
John