frank134
03-15-2009, 11:00 PM
I have read a lot on vacuum table and hope I got it right.
I have a 60 x 120 table. I am going with ametek 220volt 117123-00 vac.I divided by table up into 10 2'x2' zone and one 1 1'x 10' zone. I was going to go with six vac. I know what can be done with a feins so the question I have is how does one feins compare to one 117123 vac? one other question what software did most of you use to do your tabke or did you write it in code like the one the come from shopbot. I just edited their. WEEKS MONTHS. that was hard. what am I going to do with the bot. everything from cabinet , fruniture , signs what ever.
gary thank alot I followed a lot of your advice.
thank you
frank
I have a 60 x 120 table. I am going with ametek 220volt 117123-00 vac.I divided by table up into 10 2'x2' zone and one 1 1'x 10' zone. I was going to go with six vac. I know what can be done with a feins so the question I have is how does one feins compare to one 117123 vac? one other question what software did most of you use to do your tabke or did you write it in code like the one the come from shopbot. I just edited their. WEEKS MONTHS. that was hard. what am I going to do with the bot. everything from cabinet , fruniture , signs what ever.
gary thank alot I followed a lot of your advice.
thank you
frank