PDA

View Full Version : How can I cut this



coach
02-01-2009, 04:13 PM
I have been asked to v carve this for a Church.
How can I convert to a file for partworks?


7314

cabnet636
02-01-2009, 04:29 PM
can you get the eps from the church, they have the artwork!!

jim

bill_lumley
02-01-2009, 04:34 PM
http://vectormagic.com/

I have used this too convert an image such as yours to a file that I can cut when the original artwork is not available . It worked great . I just scanned an image I had on paper into a JPEG and let this site create my vectors that I was able to use in Partworks to generate the cut files . Bill

cabnet636
02-01-2009, 05:05 PM
used the vector majic, it will still need clanup but it worked
7315

phil_o
02-02-2009, 08:59 AM
http://www.inkscape.org/ this is a free bitmap to vector conversion program. it also can draw vector images.

dana_swift
02-02-2009, 12:09 PM
Phil, thanks for the note about Inkescape, I will be trying that one out. Its hard to beat the price.

Thanks again-

D

coach
02-03-2009, 08:42 PM
I tried both programs.
I need to clean up the image but am at a loss.
I tried to close some lines but cannot use node editing.
How can I do this next part. I am also tring to read up on the software but unfortunately I am a "show me guy" but I am trying.
Thanks......further along than I was 2 days ago so that it a positive.
David

rb99
02-03-2009, 11:05 PM
Vector Tip: To join lines select the 2 nodes and find the join button.

RB