Reversing 0,0 on table diagonally ?

[jim_stadtlander]

Is it possible to to move the 0,0 point diagonally across the table, so it would be similar to having turned your whole shopbot around without physically doing so.

Thanks, Jim

[dana_swift]

I cant guarantee this will work, but reverse the direction of X and Y by adding or removing an (-) in front of the values for X and Y on the VU command.

Then set the X Y zero location using the normal procedure at the diagonally opposite corner. That "should" work! But its only a guess, I have not tried it!

Good luck

D

[jim_stadtlander]

Thanks Dana, It works the way you say. Why it didn't work the first time I tried that, who knows........

Jim