Parameter Count Mismatch

[sleepy]

I am playing with the shop bot software in preview mode before I go pick up my new benchtop next week at the Jamboree. I design in Corel, export as a DXF convert as a shop bot file When I run part of it it says Parameter count mismatch on the table view screen. Any ideas?
Remember I am new at this.

[srwtlc]

Hi Dave,

Check your syntax in the file. You have a line of code that doesn't match. Something like J2,1,1,1 when there should be only two placeholders after the J2(J2,1,1). It could be any number of command parameter mis-matches. It should tell you what line it is on so you can check it out. Also, try the FK command on the file to check the syntax.

Scott