dmidkiff
05-22-2007, 05:13 PM
This is a project that I recently did for a customer. For some reason I can't call It ----- table. I would like for someone to explain why that word can't be used on this forum. It is a simple word and not offensive that I know of.
Gary Beckwith took my drawing and modified it and made the 3D toolpath for the chip holder and cup holder.
This pic is of the first half of this 60" game table. The game uses chips and cards.
1092
The next pic is starting to cut the chip holder after the drink holders were cut. PC router and Gary's 1/4" ballnose.
1093
The next is the whole "blank" table. It's not very good because of size, just take my word that both halves are pushed together. The cup holder is only 1/4" deep. When the customer saw it he decided that they needed to be deeper so we loaded back on the bot and made 2 more 1/4" passes. No pics.
Well Jack, I finally did it, and it was a pain. Especially since I had to do it twice because of that prohibited word.
Please Admin. tell me why I can't call my "blank" table by it's right name.
1094
Gary Beckwith took my drawing and modified it and made the 3D toolpath for the chip holder and cup holder.
This pic is of the first half of this 60" game table. The game uses chips and cards.
1092
The next pic is starting to cut the chip holder after the drink holders were cut. PC router and Gary's 1/4" ballnose.
1093
The next is the whole "blank" table. It's not very good because of size, just take my word that both halves are pushed together. The cup holder is only 1/4" deep. When the customer saw it he decided that they needed to be deeper so we loaded back on the bot and made 2 more 1/4" passes. No pics.
Well Jack, I finally did it, and it was a pain. Especially since I had to do it twice because of that prohibited word.
Please Admin. tell me why I can't call my "blank" table by it's right name.
1094