robert_cheal
11-12-2007, 05:01 PM
1095 Reference drawing was about 1"x 3"
Scanned in and traced over in AutoCad
I attempted to create hand drawn look with subtle irregularities.
The pattern had to be created to fill up a 12" X 96" board to be installed as door surrounds.
I made 4 of these.
1096
The panels were machined 1/4" deep and a relief cut at the weave point. All of the remaing detail was hand done.
On the first one I was getting tear out in the field, a new router bit helped reduce that problem.
The final back ground was stamped out with leather tool.
1097
1098
1099
For me would be interesting to discuss detailing tricks and other software options for projects like this. I have only dabbeled in projects like this. It would be fun to get better at it even for only personal projects.
Robert
Scanned in and traced over in AutoCad
I attempted to create hand drawn look with subtle irregularities.
The pattern had to be created to fill up a 12" X 96" board to be installed as door surrounds.
I made 4 of these.
1096
The panels were machined 1/4" deep and a relief cut at the weave point. All of the remaing detail was hand done.
On the first one I was getting tear out in the field, a new router bit helped reduce that problem.
The final back ground was stamped out with leather tool.
1097
1098
1099
For me would be interesting to discuss detailing tricks and other software options for projects like this. I have only dabbeled in projects like this. It would be fun to get better at it even for only personal projects.
Robert