View Full Version : Machine says it moved farther than my table size. What?
Hello. I'm just starting and trying to do everything the manual says. When I use the keypad control I moved the spindle to the 00 position and then all the way to the opposite corner and the readout said X146.651 Y80.721 I don't know why it would say this it is only a 120x60. Thanks for your help.
Check your 'Unit Values'. Make they are correct for the model shobot you have.
Good luck
Ken
How do I know what the values are supposed to be?
It will be in your control software or you can search the forum. I would give you a step by step for the software but I don't have a copy of it in front of me.
Regards,
Ken
If I open the software and go to unit values and hover the arrow over the x unit values a little window pops up and says default= and a number is that what the value is supposed to be?
Jason,
If you go to where you have installed the control software and following the directory tree down:
C:\ShopBot\ShopBot3\Settings\PRS ShopBot\
and pick the model you have, run the file and it will set all your unit values for your machine.
Don
www.dlwoodworks.com (http://www.dlwoodworks.com)
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.