Another Azek question

[dubliner]

I'm cutting 1/8th inch 9 in parts and am thinking I might just need one tab at the end point so the part doesn't slip at the last turn and give me a small scratch . Can I run a second pass that only removes the tab and wont run the whole file again? My desire would be to run all the parts on the sheet about 65, the run a second file that went in and sliced the tabs out.

[knight_toolworks]

it would be a hassle but you could copy and paste the file and cut the second vector so it is just where the tab is and then when doing the toolpath you just need to make sure the bit is on the right side. or do what I do use a long ramp like 12" also using a downcut would help if possible