Knock-down fitting

[paul60]

Is anyone using knock-down fittings. would like to know what type works best with the shopbot.
for both cabinet and furniture
thanks paul

[paco]

Check out Bill Young's on the Project Wizard.

[beacon14]

We had this discussion (http://www.talkshopbot.com/forum/show.cgi?tpc=312&post=51836#POST51836) a couple of weeks ago. I'm sure there are other fittings as well but most of my experience has been with the Rafix. One big advantage is that all maching is done into the face of the panel, there is no edge-drilling required.

[paul60]

Thanks for the information. has any one tried
Hafele one piece RTA connector? 273.93.184
it looks like a very straight forward fitting
to fit. not sure about its strength.