dubliner
01-17-2009, 05:53 PM
OK this one is confusing me. I'm experiencing a Z problem, I ran a test V cut on profile at 1 ips & .5 on the Z, I ran it to check if Z maintained its height when done. It looked lower so I measured and it was .788, but then I looked at the position window and it read .788. It seems to be cutting at the right depth but I am getting 2 flat sides(opposite each other) on circles, I was hoping it would read one inch but actually be .788 so I'd know I was losing steps Any ideas?. tx Nev