Corner cabinet

[coach]

I am trying to cut a corner base cabinet. I want to cut the top and bottom each in one piece.
I also need the back where the part is at 90 to be cut away slightly for a not so square wall.
Can this be done in part works or part wizard?
I have cab parts pro also but I am still uncomfortable with this software.
Thanks for any help.
David

[dray]

Once you start changing the angles you end up with a totally new mess. I suggest keeping it 90 deg then using a piece of scribe.

I do them in part wizard all the time.

Make sure you accurately caliper the thickness of your material before cutting the sides, back etc it will save you a ton of sanding.

[dray]

I normally make the base, top like this for ease of door installation...




7931 (0.5 k)