gene
11-23-2007, 03:21 PM
My z zero plate is not working . When i touch the bit to the plate the #1 light lights up and goes off when you break contact between the two. when i do a C2 command the bot is not recieving the signal that the bit has touched the plate, The light lights up but the bot dont reverse to do the second contact for the final depth step. I just did an upgrade to 7.2.1 motors and the 3.5.5 software complete with firmware and i know i must have overlooked something, Any suggestions ????Please ???? O.K. Preety preety please???