sleepy
02-03-2008, 01:19 PM
I had to set my benchtop up to another computer because the old one was not reading discs any longer. I usually design on another computer and save on disc as a dxf file and bring it up on the shopbot computer into wiz to do tool paths. The new computer is doing great , a lot faster etc.
My problem is it is doing things smaller than the size I designed them. I know it is a small problem that I am over looking. Any help would be appreciated. When I bring them up in wiz they are the same size I designed them in so I know it is a wrong setting on the shop bot somewhere.
My problem is it is doing things smaller than the size I designed them. I know it is a small problem that I am over looking. Any help would be appreciated. When I bring them up in wiz they are the same size I designed them in so I know it is a wrong setting on the shop bot somewhere.