scottcox
07-09-2008, 10:55 AM
Hey Botters!
Here is a recent project using Brady Watson's laser scanning service and Vectric's Cut3D.
It started with a request to make a 5 ft tall double sided wooden mask based on a smaller version.
Here is the original mask.
1546
1547
After Brady's laser scan and his cleanup of imperfections in the model, here is the 3D model (as viewed by Cut3D).
1548
1549
I took this model into TurboCad Pro v14 and mirror copied it back to back, flattened it slightly to reduce the z height, then sliced it to create the separate layers.
The using Cut3D, I carved the individual pieces from cypress slabs and included registration holes for alligning the layers. My customer assembled it and applied the finish.
Here is the finished product.
1550
1551
This was a really fun but challenging job.
On to the next!
Here is a recent project using Brady Watson's laser scanning service and Vectric's Cut3D.
It started with a request to make a 5 ft tall double sided wooden mask based on a smaller version.
Here is the original mask.
1546
1547
After Brady's laser scan and his cleanup of imperfections in the model, here is the 3D model (as viewed by Cut3D).
1548
1549
I took this model into TurboCad Pro v14 and mirror copied it back to back, flattened it slightly to reduce the z height, then sliced it to create the separate layers.
The using Cut3D, I carved the individual pieces from cypress slabs and included registration holes for alligning the layers. My customer assembled it and applied the finish.
Here is the finished product.
1550
1551
This was a really fun but challenging job.
On to the next!