git_a_grip
04-12-2008, 09:37 PM
New to probing and need some help.
I scanned to two parts at one time with 1/4'' plywood under them to keep the probe off the table. They will be run together on the same peice of wood. For some reason the area between the parts were scanned as part of the part and are connected. The probe never touched the table and the area around the parts were clear but in between its part of the part.
Any idea why???
Also can I bring the file into Partworks to remove that area before toolpathing?? I tried but could not bring it in. In the surface translator I saved it as a DXF surface. How do I get the probed info. into Partworks?? No problem getting it into Partworks 3D.
Thanks for all your help.
Bob
I scanned to two parts at one time with 1/4'' plywood under them to keep the probe off the table. They will be run together on the same peice of wood. For some reason the area between the parts were scanned as part of the part and are connected. The probe never touched the table and the area around the parts were clear but in between its part of the part.
Any idea why???
Also can I bring the file into Partworks to remove that area before toolpathing?? I tried but could not bring it in. In the surface translator I saved it as a DXF surface. How do I get the probed info. into Partworks?? No problem getting it into Partworks 3D.
Thanks for all your help.
Bob