ShopBot 10 Year Anniversary

[pete]

Perhaps I missed it, but I don't recall seeing any mention of the 10 year anniversary (1 Feb 2006) of our beloved ShopBot company on the forum. So, I would like to thank Ted Hall and his outstanding support team, including the loyal users, for creating, marketing, and continually improving this wonderful machine. Ted and team - congratulations on your 1st 10 years in business and continued success for the future. All the best. Pete

[bill.young]

Hey Peter,

Have you seen the birthday video yet...it's pretty funny. There's a link to it on http://www.shopbottools.com/features.htm

[gene_marshall]

Here Here!!!!!

[benchmark]

Hey Bill

I like the Shopbot birthday tune, What sort of router speed and feed rate did you use for cutting the cake....what is the Chocolate chip load ??


Best wishes to all


Paul

[marshawk]

Happy Birthday!!!

Great video!!!

You guys have WWWAAAAAYYYYY too much time on your hands!!!

;-)

Chip

[pete]

Bill

I watched the video - great fun. I use my SB to carve the wife's meatloaf - have to use carbide bits though.

Pete

[wcsg]

That is too funny. I have a copy of the story I think it was originally by NBC not sure, it never had a origin. But I added the article and vid to it

here's a link, 3rd story down
http://www.thesignsyndicate.com

why can't I make a link?

[bill.young]

We showed the video at the Orlando Camp and asked Scott Feimster from Onsrud what sort of bit and feed speed they should have been using...unfortunately he didn't seem to have "yellow cake and icing" in his chipload charts. Grant wanted to cut it wide open with a 1/2" upspiral (until he found out that he would have to clean it up afterwards!)

[bleeth]

Here it is as a link:

www.thesignsyndicate.com (http://www.thesignsyndicate.com)
(simplify the address-it works better for basic botters)

[wcsg]

thx,

I use to be able to make a link