henrik_o
10-10-2008, 10:47 AM
I promised Jack some images of a job where the basic deal is we take a set of existing chairs for a client, re-finish them and v-carve their "logo" in the chair.
I feel kinda silly posting these images since the whole thing is so straight-forward, but anyway:
1701
One specimen out of several hundred. A good basic chair that's in need of new finish.
1702
Testing placement etc of v-carve
1703
A re-finished chair in situ at the client's site.
1704
Close-up of the v-carve.
I guess I should have snapped a pic of the jig for doing the v-carve on the 'bot, but let me assure you it was the simplest of simple -- which is ok for a test like this but will need some work when we do hundreds at a time.
I feel kinda silly posting these images since the whole thing is so straight-forward, but anyway:
1701
One specimen out of several hundred. A good basic chair that's in need of new finish.
1702
Testing placement etc of v-carve
1703
A re-finished chair in situ at the client's site.
1704
Close-up of the v-carve.
I guess I should have snapped a pic of the jig for doing the v-carve on the 'bot, but let me assure you it was the simplest of simple -- which is ok for a test like this but will need some work when we do hundreds at a time.