What cutter are you using for surfacing???

[maginter]

What cutter are you using for surfacing??? I am wanting to sruface my hold down fixture and would like to know what you guys have used with success.

TIA,

Mark

[hines]

http://www.talkshopbot.com/forum/messages/7/15743.html?1161745768
http://www.talkshopbot.com/forum/messages/312/13465.html?1150755653
http://www.talkshopbot.com/forum/messages/7/23695.html?1188347595

[knight_toolworks]

I have an amana 2.5" bit but at 250.00 it is an investment. you can get a amana 1.75" mortise bit for around 40.00

[kfitz]

I have used a 2" 6-wing carbide cutter. Cost is $100.00 or so, the best value I could find. Mike Harvey has the info, he just bought one for his Buddy. Mike?

[harve]

I use a 2" Southeast Tool surfacing bit. Part #SE2990. Worked well for my application.

[erniek]

I just use the widest straight bit I have in the shop. 3/4" in my case. It takes 20 minutes on a PRT.

[erniek]

I just use the widest straight bit I have in the shop. 3/4" in my case. It takes 20 minutes on a PRT 96.

[gene]

I use a magnate #2706 2" that cost 35.76
Go to magnate.net
they also have a 2 3/4 " for 45.68 # 2707
the one i use does plenty good enough for me