Run Error 6 - Overrun or overturn

[stockbub]

I am trying to cut a 3d design and after about 40 minutes, it just stops and gives me this message Run Error 6 and then OVerrun or Overturn. I wrote the number of the line that it stopped at several things.

1. What does this error mean and why is it doing this?

2. How do I start this file again, only beginning at lint 59411?

3. Is there anything I can do to avoid this in the future?

It did this 3 times in a row and WOW, I am not real happy right now.

[dray]

run it in preview before cutting.

[myxpykalix]

Does it stop at exactly the same place each time?
If not, then you might check your dust collection for static electricity shorts and ground it. That would at least eliminate that as a possibility.

[stockbub]

Stops and exact line every time. I made an alternate toolpath using a raster this time it was a larger file and it cut it no problem. I was using Artcam and Spiral box toolpath. Right in a corner it froze again and again. Raster back and forth, no problem.
I got an early dust collector and the shroud was destroyed since it was made with rivots. SB is sending me the replacement so currently, I do not have a dust collector on my SB so that eliminates that problem.