bill_lumley
06-21-2009, 01:37 PM
When I first built my PRS I did not see any mention of where to put the legs in relation to the rails until after everything was but together . This has not been a big probelem until now because my air drill can not reach the entire length of the X-axis because of this .
Is it possible to shift the rails down one at a time say 5 inches by just loosening all the bolts holding the rail to the table and tapping on the end of the rail assuming I have supported the weight of the table ? Has anyone done this ? I hate to take everything apart to fix this
Thanks Bill
Is it possible to shift the rails down one at a time say 5 inches by just loosening all the bolts holding the rail to the table and tapping on the end of the rail assuming I have supported the weight of the table ? Has anyone done this ? I hate to take everything apart to fix this
Thanks Bill