PRT FOR FRAMELESS CABINETRY

[bill_f]

Hello. IS anybody using a std Prt for frameless cabinetry and if so how fast is it a cutting and drilling parts? About to buy a machine and need to know form someone using one for that.

[Forum Admin]

Bill, this was recently discussed
http://www.talkshopbot.com/forum/show.cgi?tpc=312&post=37890#POST37890

Forum Admin still trying to figure out if it's possible to clear that thread of items that should have gone private without removing all useful info.

[Ryan Patterson]

Bill,
I used to cut cabinets on a PRT and have talked with several people who are using a PRT. When I used the PRT I was Cutting 5/8” melamine at 3”/sec. The average 4x8 sheet would take about 20 min. to cut and drill the parts. I would get a second Z or the air drill to use for drilling. This will save time in bit changes. If you have any questions feel free to give me a call 239-596-0060.
Ryan
www.cabinetpartspro.com (http://www.cabinetpartspro.com)