Dimensional sign.

[toych]

Here is a picture of a sign I installed this morning. It's nothing fancy, just some v-carving and a texture.

The design was modified from my concept by the customer to include the slogan and the logo which appears on their service vehicles.

It was mounted to their restored century building where they now have their offices.

Thanks to everyone on the forum for their help.

Darren

1807

1808

[myxpykalix]

What material is that made of? That looks fantastic. You should be proud. Good job.

[toych]

Thank you Jack.

The material is Sign Foam 15lb 1 1/2". The main logo "dome" and leaf are 1/2" Sign foam applied with epoxy.

Darren

[blackhawk]

Darren - That looks fancy to me. Good job. I'm interested in your method for attaching it to the brick?

[toych]

Thanks Brad.

I fastened a Western Red Cedar cleat to the brick using Tapcon screws. The top edge is cut at 45 degrees and locks into another on the back of the sign that is held on with screws and West System Epoxy. It sits on there pretty snug. Then I ran three long stainlees screws in from below to lock it together.

Darren