Activity Stream

There are two "routines" in the current version of shopbot software that you'll want to look at -- the first is CN,14 -- which guides you through...

In SB3 go to the "Help" menu and click on "Programming and Developer Resources" then open the "ProgHand" (Programming handbook) -- last 6 or so pages...

In the new version of SB3 -- you can set up "off rack tools" -- so if you have 9 tools on your rack -- tell it to change to bit 10. The machine will...

Please contact me Frank 251 591 4650 I am interested

Can you email me a pic of the Shopbot to todd@fulshearcreek.com or text me pics to 713-805-9807. I can probably have it picked up from you.

This machine is located in Mesa, Arizona. I'm only interested in selling it in Arizona.

Thank you guys. So I have already reduced the "Z" speed to this value, and that ...makes a bit of a difference (the Z car have now one of the most...

Along with lowering the cutting speed, try reducing the Z-axis Jog speed as well in the ShopBot software. You could be losing steps during the jog...

Thank you, on this stage I have the Z movements, set up default after a fresh installation of the control software, I will try to reduce by 1/2, to...

That tick noise is the stepper motor loosing steps probably. You may can change the settings to slow down the z rapid movements and that might be...

Thank you, I send them an email so I can touch base with them. I have removed the motor, and z was moving smoothly, release one bearing and slow...

shopbot tech support is a free phone call or email away. That said, I would remove the motor and see how smooth, tight, loose, the z moves up and...

What are you using for software? With Vectric products, using a 1/4" upcut, use Profile toolpath with profile inside, conventional direction, and a...

drop 6,995$