Hi,
Longtime PRS96 owner here, since 2000. Went out to fire up SB today to cut a sign that is on deadline. Went to Jog machine and it is acting all bogged down. (standard moving is smooth but jogging is bogged and slow) Won't hold zero values either. I upgraded to newer control box 4-5 yrs ago and my jog speeds should be at 12in/sec. Did a test air cut test to see what was going on and I get and error that the cut file is outside of the table values? I couldn't get it to jog or move past certain points on the table either.
I just finished a multi file sign job with no issues? I have rebooted and checked all cables...doesn't make sense! any advice out there?

Thanks
Bill Jarvis