Add a new bit

[papatar]

HI. I'm really new to all this and this is my first post. I installed a vacuum hold down system but I now need to resurface my spoilboard with the vacuum running. When I first bought the machine and did the original surfacing I had no vacuum system yet and I can't even remember the process I used to surface the first time. I'm trying to resurface using V-Carve Pro instead of ShopBot Table Surfacer under the Tools tab. I have a Desktop Max so I entered X-36 and Y-24" for my job size and then used the offset tool to outward .25". Everything was good til I had to enter my 2" surfacing bit in the Tool Database. I clicked on the icon lower left to add a tool but then got totally confused about what they were asking me. Can anyone help with some advice about adding a tool? Thanks you for any help

[srwtlc]

Perhaps this will help....

https://www.vectric.com/support/tuto...-tool-database

[papatar]

Thank you. I'll get into this tomorrow